Onkyo TX SR308 Instruction Manual page 12

Connecting the Speaker Cables
Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of insu-
lation from the ends of the speaker
cables, and twist the bare wires tightly,
as shown.
Using Banana Plugs (North American models)
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
Push-type speaker terminals
Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the
speaker cables, and twist the bare wires tightly, as shown.
The following illustration shows which speaker should be connected to each pair of terminals.
Front right
speaker A
Connecting a Powered Subwoofer
Using a suitable cable, connect the AV receiver's SUB-
WOOFER PRE OUT jack to an input on your pow-
ered subwoofer, as shown. If your subwoofer is
unpowered and you're using an external amplifier, con-
nect the SUBWOOFER PRE OUT jack to an input on
the amp.
En
12
1/2" to 5/8"(12 to 15 mm)
Surround right
Surround left
speaker
speaker
Front left
Center
speaker A
speaker
Speakers A
3/8" to 1/2"(10 to 12 mm)
Front right
speaker B
I E N UT
Powered subwoofer
Front left
speaker B
Speakers B
LINE INPUT