Table of Contents
Advertisement
Perfect Fit Guide
step one - measure
Before transferring into the Glider, measure for
approximate (A) seat depth and seat to (B) foot plate
settings.
!
Caution: These adjustments are only to be made while the
unit is unoccupied.
step two - seat depth
To adjust seat depth, loosen the knob under the
seat (C). Use measurement (A) and measure from
the inside of the knee pad to the back. Depress the
snap button on the adjustment tube while moving
the back (D). Adjust the seat depth until the proper
measurement has been reached. Tighten the knob
(C) after adjusting.
!
Caution: The following adjustments are only to be made in
the seated position
step three - back angle
After achieving the desired seat depth, rotate the
back angle (E) adjustment knob so the (F) seat/back
angle indicator on the side of the unit is in the green
area prior to standing.
Note: Repeat steps 2 and 3 for each color adjustment.
step four - foot plates
Use the (B) measurement to adjust the foot plate
height. Loosen the (G) knobs on the foot plates to
adjust height. Tighten the knobs after positioning.
The knees should be slightly lower than the hip (H).
step five - positioning
Position the user's hips as close as possible to (I)
Glider's hip pivot.
step six - knee pad
Slide into knee pads (J) and secure the calf straps
behind the knees.
Inspect your standing frame periodically to ensure it is in safe operating condition.
Page 19 - Perfect Fit Guide
(A)
(C)
(E)
(G)
(I)
(B)
(D)
(F)
(H)
(J)
Advertisement
Table of Contents
