Resetting The Remote Controller - Onkyo TX-SR876 User Manual

Controlling Other Components—Continued
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via u are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is con-
nected with an u cable and an analog
audio cable (RCA).
See page 50 for details.
2
Enter the appropriate remote control code
to the REMOTE MODE button.
• [DVD] REMOTE MODE button
5002: Onkyo DVD player with u
• [CD] REMOTE MODE button
6002: Onkyo CD player with u
• [MD] REMOTE MODE button
6008: Onkyo MD recorder with u
• [CDR] REMOTE MODE button
6006: Onkyo CD recorder with u
• [DOCK] REMOTE MODE button
6004: Onkyo RI Dock with u
See the previous page for how to enter remote
control codes.
3
Press the REMOTE MODE button, point
the remote controller at the AV receiver,
and operate the component.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via u, use
the following remote control codes:
• [DVD] REMOTE MODE button
5001: Onkyo DVD player without u (default)
• [CD] REMOTE MODE button
6001: Onkyo CD player without u (default)
• [MD] REMOTE MODE button
6007: Onkyo MD recorder without u
• [CDR] REMOTE MODE button
6005: Onkyo CD recorder without u
• [DOCK] REMOTE MODE button
6003: Onkyo RI Dock without u
138
Note:
If you connect an u-capable Onkyo MiniDisc
u
recorder, CD recorder, or RI Dock to the TAPE IN/OUT
jacks, or connect an RI Dock to the AUX 1 jacks, for u
to work properly, you must set the Input Display accord-
ingly (see page 63).
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default
remote control code.
1
2

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
2
While holding down the REMOTE
MODE button that you want to
reset, press the TV [9] button.
The Remote indicator flashes three
times.
Press the REMOTE MODE button
again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
The [DVD] and [CD] REMOTE
MODE buttons are preprogrammed
with remote control codes for control-
ling Onkyo DVD players and CD play-
ers, respectively. When these buttons
are reset, the preprogrammed codes are
restored.
While holding down the
[RECEIVER] REMOTE MODE but-
ton, press the [STANDBY] button.
The Remote indicator flashes five
times.
Press the [RECEIVER] REMOTE
MODE button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.