Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near
any area of potential danger. Replace any decal that is damaged or lost.
Assembly
Handles (Fig. 2)
1.
Mount lower handle against inside of deck with
5/16 – 18 x 1–1/4" lg. capscrews and locknuts.
2.
Align center hole in handle latch with hole in
handle and secure in place with 5/16 – 18 x
1–1/2" lg. capscrews and locknuts.
Note:
Handle can be set in any of three
positions, depending on operator
height. Simply move capscrew into
different hole in handle latch.
4
3.
Mount upper handle to lower handle with 5/16 –
18 x 1–1/2" lg. capscrews and locknuts.
Gas Tank
1.
Start self–tapping screws (Fig. 3) into bottom of
gas tank and then remove screws.
2.
Hook plastic clips on rear of gas tank onto gas
tank bracket (Fig. 3).
3.
Secure gas tank to tank base with (2)
self–tapping screws (Fig. 3). Do not overtighten.
4.
Hook gas tank retainer onto gas tank and slide
end of retainer into hole in tank bracket. Secure
retainer to tank bracket with locknut (Fig. 3).