Setup; Installing The Handle - Toro 26634 Operator's Manual

Setup

Note: Determine the left and right sides of the machine
from the normal operating position.

Installing the Handle

1. Loosen the knobs on the mounting brackets (Fig. 2).
1
2
3
Figure 2
1. Handle
2. Mounting bracket (2)
2. Position the mounting brackets vertically so the holes
face upward.
3. Slide the handle ends into the holes in the mounting
brackets until the handle ends fully seat into the
brackets (Fig. 2).
Note: Ensure that the blade brake cable and the traction
cable rest on top of the left mounting bracket (Fig. 3).
Figure 3
1. Blade brake cable
4. Rotate the handle and the mounting brackets rearward
until the brackets fit securely into the housing pockets
(Fig. 2).
5. Tighten the knobs until the edges of the slots on top of
the mounting brackets touch.
4
792a
3. Knob (2)
4. Housing pocket (2)
1
2
793a
2. Traction cable
6. Secure the cables to the lower side of the left hand tube
with a cable tie (Fig. 4). Position the cable tie 1 inch
(25 mm) from the bend in the handle as shown in
Figure 4.
Figure 4
1. Cable tie
Note: Ensure that the cables do not interfere with the
raising or lowering of the discharge door.
7. Cut any excess length from the end of the cable tie.
8. Secure the control lever to the control bar with a bolt
and a locknut (Fig. 5).
Figure 5
1. Control lever
2. Control bar
6
1
2
791
2. 1 inch (2.5 cm)
2
1
3
1620
3. Bolt
4. Locknut (not shown)