Adjusting Grass\Mud Scraper; Adjust Pto Bellcrank - Toro ProLine 30197 Operator's Manual

Adjusting Grass\Mud Scraper

1. Loosen the locknut holding scraper to the engine
frame (Fig. 47).
2. Rotate scraper until they align with center of
pulley grooves (Fig. 47).
3. Tighten the locknut (Fig. 47).
Note: The scraper must not contact the pulley
on the sides or bottom of grooves.
Re-adjust if necessary.
2
1
Figure 47
1. Scraper
2. Locknut
3
m–3776
3. Pulley

Adjust PTO Bellcrank

4. Engage PTO lever and check the clearance
between the bellcrank and the axle shaft (Fig.
48). Space should be 1/4" (6mm).
5. If adjustment is required, remove hairpin cotter
and clevis pin from bellcrank. Rotate clevis
clockwise on rod to increase or counterclockwise
to decrease clearance (Fig. 48).
1
2
3
Figure 48
1. 1/4" (6mm)
2. Hairpin cotter
Maintenance
4
m–3860
3. Clevis pin
4. Clevis
39