Table of Contents
Advertisement
2
Installing the Recoil-Start
Rope
No Parts Required
Procedure
Pull the recoil-start rope through the rope guide on the
handle
(Figure
6).
1. Recoil-start rope
Note: To make the rope easier to install, squeeze the
blade-control bar on the handle.
Figure 6
2. Rope guide
3
Filling the Engine with Oil
No Parts Required
Procedure
Important: Your machine does not come with oil in
the engine. Before starting the engine, fill the engine
with oil.
1. Move the machine to a level surface.
2. Remove the dipstick
the crankcase capacity of oil into the oil-fill tube.
Note: Max. fill: 0.59 L (20 oz), type: SAE 30 or SAE
10W-30 detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.
1. The oil level is at its
maximum.
2. The oil level is too
high—remove oil from
the crankcase.
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in.
5. Remove the dipstick and read the oil level on the
dipstick
(Figure
7).
•
If the oil level is too low, add a small amount of
oil slowly to the oil-fill tube, and then repeat steps
9
(Figure
7) and pour about 3/4 of
Figure 7
3. The oil level is too
low—add oil to the
crankcase.
Advertisement
Table of Contents
