Cutting Leaves; Recommended Maintenance Schedule(S) - Toro Super Recycler 20792 Operator's Manual

– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your mower.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
– Set the cutting height on the front wheels one
notch lower than the rear wheels. For example,
set the front wheels at 2-1/4 inches (60 mm) and
the rear wheels at 2-3/4 inches (70 mm).
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Before storage
Yearly
Important: Refer to your
Maintenance Procedure
• Change the engine oil.
• Check the engine oil level.
• Ensure that the engine stops within 3 seconds after releasing the blade control bar.
• Clean grass clippings and dirt from under the mower.
• Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
• Change the engine oil.
• Clean the cooling system (refer to your engine owner's manual).
• Replace the spark plug (refer to your engine owner's manual).
• Empty the fuel tank before repairs as directed and before annual storage.
• Replace the air filter (more frequently in dusty operating conditions).
• Check the spark plug (refer to your engine owner's manual).
• Lubricate the rear wheel gears.
• Refer to your Engine Operator's Manual for any additional yearly maintenance
procedures.
Engine Operator's Manual

Cutting Leaves

• After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need to
make more than one pass over the leaves.
• If there are more than 5 inches (13 cm) of leaves
on the lawn, set the front cutting height one or two
notches higher than the rear cutting height.
• Slow down your mowing speed if the mower does
not cut the leaves finely enough.
for additional maintenance procedures.
13