Lubrication; Greasing The Bearings And Bushings - Toro 07383 Operator's Manual

Hide thumbs Also See for 07383:
Table of Contents

Advertisement

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 100 hours (lubricate more frequently
in heavy duty applications).
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium-Base Grease.
The grease fitting locations and quantities are as follows:
Ball joints (4), tie rods (2), pivot mounts (2) and steering
cylinder (2) (Figure 39)
Spring tower (2) (Figure 40)
Clutch (1) and brake (1) (Figure 41)
U-joint (18) and 4 wheel drive shaft (3) (Figure 42)
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
Figure 39
40
Figure 40
Figure 41

Advertisement

Table of Contents
loading

This manual is also suitable for:

0738407384tc0738607386h07386tcWorkman hdx ... Show all

Table of Contents