Package Contents; Electrical Safety - DeWalt DCS355 Original Instructions Manual

Have defective cords replaced
immediately.
Charge only between 4 ˚C and 40 ˚C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack.
Charges Li-Ion battery packs.
See Technical Data for charging time.
Only for indoor use.

Package Contents

The package contains:
1 Adaptor for all blades
1 31 mm x 43 mm Fastcut wood blade
1 31 mm x 43 mm Wood with nails blade
1 Blade adaptor hex key
1 Sanding-pad
25 Assorted sandpaper pieces
1 Instruction manual
**DCS355D2/DCS355M2 ONLY:
1 100 mm Semicircle blade**
1 Rigid scraper blade**
1 Dust extraction adaptor**
1 Cutting guide**
1 Cutting guide hex key**
1 9.5 mm x 43 mm Wood detail blade**
1 3 mm Carbide grout removal blade**
(100 mm half moon)
1 Charger**
2 Li-Ion battery packs**
1 TStak kitbox**
NOTE: Battery packs, chargers and kitboxes are not
included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1, 2)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Variable speed trigger
b. LED Worklight
c. Accessory clamp lever
d. Lock on/off button
e. Accessory side mount slots
f. Cut guide block
g. Cut guide arm
h. Battery pack
i. Battery release button
j. Fuel gauge button
INTENDED USE
This oscillating multi-tool is designed for professional
detail sanding, plunge cutting, flush cutting, removal
of excess materials and surface preparation
applications.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
This oscillating multi-tool is a professional power
tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
e
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
English
11