Recycling; Troubleshooting - Philips Intelia Deluxe HD8902 Manual

English
20

Recycling

Troubleshooting

Problem
The machine does not
switch on
The machine is in DEMO
mode.
The drip tray is quickly
filled.
The coffee grounds
container full icon remains
displayed.
The brew group cannot
be removed.
- This symbol means that this product shall not be disposed of with normal
household waste (2012/19/EU).
- Follow your country's rules for the separate collection of electrical and
electronic products. Correct disposal helps prevent negative
consequences for the environment and human health.
Cause
The machine is disconnected or
the main switch is in the OFF
position.
The standby button has been
pressed for more than 8 seconds.
This is normal. The machine uses
water to rinse the internal circuit
and brew group. Some water
flows through the internal system
directly into the drip tray.
The coffee grounds container
was emptied while the machine
was switched off.
The coffee grounds container
was placed back too fast.
The brew group is not positioned
correctly.
The coffee grounds container is
not removed.
The machine is still in the
descaling process.
Solution
Check if the mains cord is inserted
correctly
Make sure the main switch is set in ON
position.
Switch the machine off and then on
again using the main switch on the
back of the machine.
Empty the drip tray when the 'drip tray
full' full indicator pops up through the
drip tray cover.
Place a cup under the dispensing
spout to collect rinsing water.
Always empty the coffee grounds
container while the machine is ON. If
the coffee grounds container is
emptied while the machine is switched
off, the coffee cycle counter is not
reset. In that case, the 'empty coffee
grounds container' message will stay
on the display even though the
container is not full.
Do not place back the coffee grounds
container until the screen message
prompts you to put it back
Close the maintenance door. Switch
the machine off and back on again.
Wait for the machine ready screen to
appear and then remove the brew
group.
Remove the coffee grounds container
before removing the brew group.
You cannot remove the brew group
when the descaling process is active.
First complete the descaling process
and then remove the brew group.