Using The Self-Propel Drive (Model 21132 Only); Stopping The Engine; Bagging The Clippings - Toro Recycler 21131 Operator's Manual

Using the Self-propel Drive
(model 21132 only)
To operate the self-propel drive, squeeze the self-propel drive
bar toward the handle and hold it
1. Self-propel drive bar
To disengage the self-propel drive, release the self-propel
drive bar.
Note: The maximum self-propel ground speed is fixed.

Stopping the Engine

To stop the engine, release the engine stop handle.
Important: When you release the engine stop handle,
both the engine and the blade should stop within 3
seconds. If they do not stop properly, stop using your
mower immediately and contact an Authorized Service
Dealer.

Bagging the Clippings

Install the grass bag to collect the clippings.
1. Lift the rear deflector, remove the mulch plug
15), and install the grass bag onto the lugs
Figure 13).
g018106
Figure 13
(Figure
1. Rear door
2. Lug
2. Release the rear door.
3. Mow with the grass bag attached.
4. When the bag is full, stop the engine, remove the grass
bag from the mower, and empty the contents.
Note: To convert from bagging to recycling, remove the
grass bag, replace the mulch plug you removed in Step 1, and
lower the rear door
(Figure
14).
1. Mulch plug
11
Figure 14
3. Grass bag
(Figure 15).
1
g017756
Figure 15
g01771 1