Checking The Engine-Oil Level; Adjusting The Cutting Height - Toro Super Recycler 20383 Operator's Manual

G027604

Checking the Engine-Oil Level

Service Interval: Before each use or daily
Max. fill: 0.59 L (20 oz), type: SAE 30 or SAE 10W-30
detergent oil with an API service classification of SF, SG, SH,
SJ, SL, or higher.
1. Move the machine to a level surface.
2. Remove the dipstick
1. The oil level is at its
maximum.
2. The oil level is too
high—remove oil from
the crankcase.
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in.
5. Remove the dipstick and read the oil level; refer to
Figure 13.
•
If the oil level is too low, add a small amount of
oil slowly to the oil-fill tube, and then repeat steps
1 cm (1/2 inch)
Figure 12
(Figure 13).
G017459
Figure 13
3. The oil level is too
low—add oil to the
crankcase.
3 through 5
correct.
•
If the oil level is too high, drain the excess oil until
the oil level on the dipstick is correct. To drain the
excess oil, refer to
19).
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
6. Install the dipstick securely.

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set all four wheels to
the same height.
Note: To raise the machine, move all 4 cutting height levers
forward; to lower the machine, move them all rearward
(Figure 14).
A = 3 cm (1-1/4 inches)
B = 4 cm (1-3/4 inches)
C = 6 cm (2-1/4 inches)
D = 7 cm (2-3/4 inches)
10
until the oil level on the dipstick is
Changing the Engine Oil (page
E = 8 cm (3-1/4 inches)
F = 1 1 cm (4-1/4 inches)
G = 1 1 cm (4-1/4 inches)
G027605
Figure 14