Setup; Loose Parts; Installing Drive Wheels; Checking The Tire Pressure - Toro 74234 Operator's Manual

Setup

Note: Determine the left and right sides of the machine
from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
Rear Wheels
Retaining rod
Bolt, 5/16 x 1 in.
Locknut, 5/16 in.
Control lever—right
Control lever—left
Bolt, 3/8 x 1 in.
Spring washer, 3/8 in.
Key
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card
Oil drain hose

Installing Drive Wheels

1. Uncrate the mower.
2. Remove the wheel nuts from the rear wheel hubs.
3. Align the holes. Mount drive wheels with the valve
stem to the outside of the traction unit.
4. Secure using wheel nuts provided. Torque to 95 ft.–lb.
(128 N M).
Important
Make sure that wheel nuts are torqued to
95 ft.–lb. (128 N M).

Checking the Tire Pressure

Check the air pressure in the front and rear tires (Fig. 2).
Pressure: 13 psi (90 kPa)
QTY.
2 Installing wheels to traction unit
1
1

Installing the seat retaining rod

1
1
1
Installing the motion control levers
4
4
2
1 Read before operating machine
1
1
1 Fill out and return to Toro
Changing the Engine Oil in the Maintenance
1
Section
Installing the Seat Retaining
Rod
1. Tilt seat up. Remove the locknut (5/16 in.) from bolt
attaching seat retaining rod to seat frame (Fig. 3).
14
USE
1
Figure 2
1. Valve stem
m–1872