Installing The Fuel Tank; Flange Nut, 3/8 Inch; Fuel Tank With Studs Installed; Locknut, 5/16 Inch - Toro 30438 Operator's Manual

1
2
4
5
6
7
8
Figure 4
1. Upper handle
2. Rear frame

3. Flange nut, 3/8 inch

4. Flange bolt, 3/8 x 1 inch
Note: Handle assembly must be installed before fuel tank is
installed.
3
m–6591
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
15
Step
3

Installing the Fuel Tank

Parts needed for this step:
Qty.
1

Fuel tank with studs installed

2

Bolt, 5/16 X 7/8 inch

2 Lock nut, 5/16 inch
4

Washer, 5/16 inch

1 Hose clamp
2

Lock washer, 5/16 inch

2 Spring
Procedure
1. Align fuel tank with the top of the rear frame (Fig. 5).
2. Secure the right side of the fuel tank to the rear frame
with 2 bolts (5/16 x 7/8 inch), lock washers (5/16 inch)
and washers (5/16 inch) (Fig. 5).
3. Secure the left side of the fuel tank to the rear frame
with 2 studs, washers (5/16 inch), springs and locknuts
(5/16 inch) (Fig. 5).
Note: Tighten left side of the fuel tank until it is completely
tight and then unscrew locknut one full turn. This will
allow the spring to work.
Part