Removing The Machine From Storage - Toro 29645 Operator's Manual

1. Upper handle knob
2. Loosen the handle knobs until you can move the
handle freely (Figure
3. Move the handle forward as shown in
Removing the Machine from
Storage
1. Remove the spark plug and spin the engine rapidly by
pulling the recoil-start handle to blow the excess oil
from the cylinder.
2. Install the spark plug and tighten it with a torque
wrench to 20 N-m (15 ft-lb).
3. Connect the wire to the spark plug.
Figure 27
2. Handle knobs
27).
Figure 27.
17