Recording From Cd; Aux In Connection; Specifications - Sylvania SRCD286 Instructions Manual

Programming the CD Player
To program the CD Player, please ensure the CD is in STOP mode.
1. Press the CD PROGRAM button to begin programming the CD player.
2. Press the CD SKIP/SEARCH FORWARD or CD SKIP/SEARCH BACKWARD buttons, to select
your desired track.
3. Once the number of the desired track appears on the display, press the PROGRAM button
again to store the track in the memory.
4. Repeat steps 2 to 3 to store more tracks in the memory. You can store a maximum of 20 tracks.
5. Press the CD PLAY/PAUSE button to play the disc in the programmed order.
6. To stop playing, press the CD STOP button.
7. To cancel the programmed tracks, press the CD STOP button or select a different function
mode (AUX, TAPE or RADIO).
Repeat Mode
Repeat 1: When the CD REPEAT button is pressed once, the REPEAT LED Indicator will light and
flash continuously. This single track will be repeated.
Repeat All: When the CD REPEAT button is pressed twice, the REPEAT LED Indicator will stay
lighted. The whole disc will be played repeatedly.
To Cancel Repeat Function: Press the CD REPEAT button until the lighted REPEAT LED Indicator
turns off.
CASSETTE OPERATION
INSERTION AND REMOVAL OF CASSETTES
1. Press the Cassette EJECT button to open the Cassette Door.
2. Slip your cassette tape into the holder with the exposed side facing up (the side for playing
faces you).
3. Close the Cassette Doors securely before starting.
4. When finished playback, press the Cassette STOP button, then the Cassette EJECT button to
open the Cassette Door, and retrieve your cassette tape.
PLAYBACK
1. Set the FUNCTION Selector to the TAPE position.
2. Insert your cassette tape with the exposed side facing up.
3. Press the Cassette PLAY button to activate playback.
4. Set the Volume to the desired level.
5. Press the Cassette STOP button when finished.
RECORDING
RECORDING FROM THE RADIO
1. Set the FUNCTION Selector to the RADIO position.
2. Tune in your station and put in your cassette tape with the exposed side facing up.
3. Press the Cassette RECORD button and the Cassette PLAY button at the same time to start
recording.
4. Press the Cassette STOP button when finished.
- EN 6 -

RECORDING FROM CD

1. Set the FUNCTION Selector to the CD position.
2. Insert a blank cassette into the deck with the exposed side pointing up (the side for recording
faces you).
3. Press the Cassette RECORD button and the Cassette PLAY button at the same time, the unit
will then go into recording mode.
4. Activate the CD player.
5. To stop recording, press the CD STOP button, then press the Cassette STOP button.
AUX-IN CONNECTION
1. Insert the audio cable (requires 3.5mm stereo plug, not supplied) into the Line Out Jack or
Phones Jack on your MP3 Player into the corresponding AUX Input Jack on your main unit;
2. Turn on your main unit and slide the FUNCTION Selector to AUX position;
3. Make sure your MP3 Player is turned on, and follow your MP3 Player's instruction;
4. To stop this function, simply slide the FUNCTION Selector to TAPE position.
HEADPHONES
Headphones should have a 3.5mm diameter stereo plug and an impedance of 8-32 ohms.
When headphones are connected, the speakers are automatically disconnected.

SPECIFICATIONS

Frequency Range: AM 530 - 1710 KHz
FM 88 - 108 MHz
Power Supply: AC 120V ~ 60Hz
DC 9V (6 "C" size batteries, not included)
Note: Specifications and the design are subject to possible modifications without notice due to
improvement.
- EN 7 -