Positioning The Seat; Pushing The Machine By Hand - Toro 74177 Operator's Manual

4
3
2
Figure 23
1. Gage wheel
2. Stud
3. Washer
Adjusting the Center Rollers
1. Disengage the power take off (PTO) and turn the
ignition key to Off. Move the control levers to the
neutral locked position and apply the parking brake.
2. After adjusting the height-of-cut, remove the bolt and
nut (Fig. 24).
3. Select a hole so that the gage wheel is positioned to the
nearest corresponding height-of-cut desired (Fig. 24).
Note: Do not adjust the rollers to support the deck.
4. Reinstall the bolt, center rollers, and nut (Fig. 24).
3
1
Figure 24
1. Center rollers and spacer
2. Nut
1
5
m–4167
4. Nut
5. Wheel nut and washer.
Do not remove.
2
m–4124
3. Bolt
22

Positioning the Seat

The seat can move forward and backward. Position the seat
where you have the best control of the machine and are
most comfortable.
1. To adjust, move the lever sideways to unlock the seat
(Fig. 25).
2. Slide the seat to the desired position and release the
lever to lock the seat in position.
1
Figure 25
1. Adjustment lever

Pushing the Machine by Hand

Important
Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off.
2. Rotate the by-pass valves counterclockwise 1 turn to
push. This allows hydraulic fluid to by-pass the pump,
enabling the wheels to turn (Fig. 26).
Important
Do not rotate the by-pass valves more than
1 turn. This prevents the valves from coming out of the
body and causing fluid to run out.
Changing to Machine Operation
Turn the by-pass valves in to operate the machine (Fig. 26).
Note: Do not over tighten the by–pass valves.
Note: The machine will not drive unless the by-pass valves
are turned in.
m–3655