Setting Up The One For All 1; Direct Code Set Up - One for All URC-7710 Instruction Manual

Setting up the ONE FOR ALL 1

(How to set-up the ONE FOR ALL 1 to control your television)
To set up the ONE FOR ALL 1 for your television:
1.
Make sure your device (television) you wish to operate
is switched on (not in standby).
2.
3.
4.
_ _ _ _
5.
- Most TV's do not switch back on pressing the POWER key, please try
pressing a "number" key or the "TV-text off" key to switch your TV
back on.
- If your device does not respond, follow steps 1 through 5 with each
code listed for your brand. If none of the codes listed for your brand
operate your device, then try the Search Method described on page 7,
even if your brand is not listed at all.
- Some codes are quite similar. If your device does not respond or is not
functioning properly with one of the codes, try another code listed
under your brand.
- Write your device code in the applicable four digit boxes
provided in the battery compartment and on page 8 for future
reference.
6 6
Direct code set-up
Find the code for your device in the Code List
(page 10 - 14). The device codes are listed per brand
name. Also the most popular code for each brand is
listed first. If your brand is not listed at all, try
the Search Method on page 7.
Press and hold down MAGIC until the red light
blinks twice (the red light will blink once then twice).
Enter your four-digit device code using the num-
ber keys. The red light will blink twice.
Now aim the ONE FOR ALL 1 remote at your
device (television) and press POWER. If your
device switched off, the ONE FOR ALL 1 is ready to
operate your device.
WWW.ONEFORALL.COM WWW.ONEFORALL.COM