Table of Contents
Advertisement
4
3
2
Figure 22
1. Gage Wheel
2. Stud
3. Spring Disk
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. To adjust, move the lever sideways to unlock seat
(Fig. 23).
2. Slide the seat to the desired position and release lever
to lock in position.
1
Figure 23
1. Adjustment lever
Pushing the Machine by Hand
Important
Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
1
5
m–4161
4. Flange Nut
5. Wheel nut and washer. Do
Not Remove.
m–3655
23
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move levers to neutral locked
position and apply parking brake.
2. Rotate the by-pass valves counterclockwise 1 turn to
push. This allows hydraulic fluid to by-pass the pump
enabling the wheels to turn (Fig. 24).
Important
Do not rotate by-pass valves more than 1
turn. This prevents valves from coming out of the body
and causing fluid to run out.
3. Disengage parking brake before pushing.
Changing to Machine Operation
1. Rotate the by-pass valves clockwise 1 turn to operate
machine (Fig. 24).
Note: Do not over tighten the by–pass valves.
Note: The machine will not drive unless by-pass valves
are turned in.
1
Figure 24
1. By-pass valve
Using a Rollover Protection
System (ROPS)
A ROPS is available and its use is recommended for areas
where there are slopes, drop–offs or water. Contact an
Authorized Service Dealer for information on obtaining
ROPS for your machine.
Important
When operating a machine with ROPS
always use the seat belt.
m–6124
Hide quick links:
Advertisement
Table of Contents
