Kenwood DDX6027 Service Manual page 28

DDX6027/6027Y/7017
DDX7037/7047/7067
Screen Management section
• While in the Test Mode (Including connection with special
µ-com/jig), the startup will be with VIDEO screen. → Transi-
tion to Test Mode Main screen is made with [FNC] key.
• In coordination with V.SEL, AVOUT is also switched. (AVOUT
with Graphic and NAVI can be anything.)
AVIN1 – (AVIN2) – (TV) – R-CAM – NAVI-DVD (NO specific
order)
• Easy Control screen can be skipped using [FNC] key.
• Parking detection is ignored in Test Mode. However, Park-
ing is not ignored when Unit is special.
• Reverse condition occurring in Test Mode will be made On
condition (VSEL always has RCAM). However, when Unit is
special, it will be as usual.
(When detected, Reverse will cause R-CAM interruption,
as usual.)
• Default screen of System Setup will be made System 2.
• Default screen of Audio Setup will be made Speaker Setup.
• Default speaker selected of Speaker Setup will be made
Sub-woofer.
• When VIDEO 1 video is input or at signal switching (NTSC
↔ PAL) will not be OSD displayed. (OSD display will be
made at V.SEL switching. Display will not be made at the
time of VIDEO 1.)
BEEP Control
• Beep will be sound regardless of destinations
(When Standby sourcing, Beep will not be sound as PWIC
limitation item.)
SI Control
• Default of SI will be On.
AVIF
• AVIN2 (AVIN1 for models with no AVIN2) Interruption will
be made default On.
• NAVI interruption SP setting will be default FRONT ALL.
• V-IN mirror mode switching will be conducted with remote
controller Tenkey [3].
• R-CAM Interruption will be made default On.
28
TEST MODE
SCREEN Adjustment
• Default is center. With one click, FullDown ↔ Center ↔
FullUp.
• Default for BRT is MAX.
Audio
• Default for Volume is Step 30.
• Bal/Fad setting is one click: Min ↔ Center ↔ Max
• Default for LineMute is On.
• Xover setting is one click: Min ↔ Max
• Tone setting is one click: Min ↔ Center ↔ Max
• Default for Tone (EQ) is Flat.
• Default for SystemQ is OFF.
• When equipped with Digital Out terminal, setting will be for
always output On.
TUNER
• When E2PROM cannot be accessed, Error display will be
made. (Tuner screen)
• Forced Narrow/ Middle/ Wide switching of K3I.
By long pressing of Preset 4: Forced Narrow (∗∗∗.∗1MHz)
By long pressing of Preset 5: Forced Middle (∗∗∗.∗2MHz)
By long pressing of Preset 6: Forced Wide (∗∗∗.∗3MHz)
DVD
• CD media KTD-02A and DVD media, TDV-540A/TTD-100
are used.
• When Test Mode is started up in with Disc and Panel Open
condition, the disc will not be ejected (The same as usual)
• Region code is set at the minute position of the time code.
• At time of CDDA media, RDM key will cause transfer to Track
28.
• At time of CDDA media ,pressing TrackUP key will cause: 9
→ 15 → 10 → 11 → 12 → 13 → 14 → 9.
• When loading, Title1-Chapter1 (Indicated with
next page)
in table