Toro 07213TC Operator's Manual page 22

1
6
3
1. Tilt steering lever
2. Ignition switch
3. Horn button
4. Coolant temp. gauge
5. Engine low oil pressure light
6. Charge indicator
7. Glow plug switch
8. Glow plug indicator light
Engine Low-Oil Pressure Light (Fig. 19)—Light
glows if engine oil pressure drops below a safe level
while engine is running. If light flickers or remains
ON, stop vehicle, turn off engine and check oil level.
If oil level was low, but adding oil does not cause light
to go out when engine is restarted, turn engine off
immediately and contact your local TORO distributor
for assistance.
Important Do not operate vehicle until repair is
complete. Failure to observe this precaution may result
in damage to the engine.
Glow Plug Switch and Indicator (Fig. 19)—Use to
preheat engine cylinders prior to cold engine starting
procedures—cylinders are preheated automatically
during warm engine start operation. For cold starting,
push switch lever upward and hold while watching
indicator. Indicator will glow orange when the glow
plugs are activated. Length of time necessary to
preheat cylinders should be determined by
atmospheric temperature; refer to Starting /Stopping
Engine, p. 24.
Ignition Switch (Fig. 19)—The ignition switch, used
to start and stop the engine, has three positions: OFF,
ON /Preheat and START. Rotate key clockwise—
START position—to engage starter motor. Release key
when engine starts. The key will move automatically
to the ON position. To shut engine off, rotate key
counterclockwise to OFF position.
5
8
2
7
Figure 19
Charge Indicator (Fig. 19)—Illuminates when
battery is being discharged. If light illuminates during
operation, stop vehicle, turn off engine and check for
possible causes, such as alternator belt.
Important
not operate vehicle until adjustment or repair is
complete. Failure to observe this precaution may result
in damage to the engine.
4
To check operation of warning lights:
1. Apply parking brake.
2. Turn ignition key to "ON", but do not start
engine. The charge indicator and oil pressure
lights should glow. If any light does not function,
either a bulb is burned out or there is a
malfunction in the system that must be repaired.
Note: High water temperature function on warning
light cluster is not used.
Hour Meter (Fig. 20)—Indicates the total hours of
machine operation. The hour meter starts to function
whenever the key switch is rotated to "ON" position.
Light Switch (Fig. 20)—Toggle switch to activate
headlights. Push to turn lights "ON".
3rd High-Lockout Switch (Fig. 20)—Moving switch
to slow-position and removing key will prevent use of
third gear when in the High range. Engine will shut off
if shift lever is moved to third gear when in High
range. Key is installed with teeth pointing downward.
Push key in to turn. Key is removable in either
position.
2
1. Light switch
2. Hour meter
3. Fuel gauge
4. 3rd High-lockout switch
5. Steering wheel
22
If alternator belt is loose or broken, do
3
4
Figure 20
5
1