Transporting Machines - Toro 31230 Operator's Manual

WARNING
Loading a unit onto a trailer or truck increases the
possibility of backward tip-over and could cause
serious injury or death.
• Use extreme caution when operating a unit on
a ramp.
• Use only a single, full width ramp; Do not use
individual ramps for each side of the unit.
• If individual ramps must be used, use enough
ramps to create an unbroken ramp surface wider
than the unit.
• Do not exceed a 15 degree angle between ramp
and ground or between ramp and trailer or truck.
• Avoid sudden acceleration while driving unit up
a ramp to avoid tipping backward.
• Avoid sudden deceleration while backing unit
down a ramp to avoid tipping backward.
Figure 20
1. Trailer
2. Full width ramp
3. Not greater than
15 degrees
4. Full width ramp—side view

Transporting Machines

WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can lead
to accidents causing personal injury.
Do not drive machine on a public street or roadway
without signs, lights, and/or markings required by
local regulations.
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary lighting and
marking as required by law. Please carefully read all the safety
instructions. Knowing this information could help you or
bystanders avoid injury.
To transport the machine:
•
Ensure that your vehicle, hitch, safety chains, and trailer
are adequate for the load you are pulling and that they
meet all local traffic regulations for your area.
•
Lock the brake and block the wheels.
•
Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes as required by local traffic
regulations in your area
23
(Figure 21).