14. Check that the machine does not creep in neutral with
the park brakes disengaged.
Adjusting the Motion-control
Damper
The top damper mounting bolt can be adjusted to obtain a
more desired motion-control lever resistance. See Figure 82
for mounting options.
Right-hand control shown
1. Torque the locknut to 23 N-m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Figure 82
Adjusting the Motion Control
Neutral-lock Pivot
The flanged nut can be adjusted to obtain a more desired
motion-control lever resistance when moving it to the
neutral-lock position. See Figure 83 for adjustment options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
Note: For more resistance, tighten the flanged nut.
Note: For less resistance, loosen the flanged nut
3. Tighten the jam nut.
1. Flanged nut
54
Figure 83
2. Jam nut