Velleman WS1080 User Manual page 4

1. Install your outdoor weather station on a suitable location minding the wind direction markings.
Connect the anemometer to the wind vane phone jacket. Connect the wind vane to the thermo-
hygrometer WIND phone jacket. Connect the rain sensor to the thermo-hygrometer RAIN phone
jacket. Finally, insert 3 x AA batteries into the weather station respecting the polarity.
2. Insert 2 x AA batteries into the receiver respecting the polarity. Wait for the two stations to
synchronize. This synchronisation may take a couple of minutes. Do not touch the screen during
synchronisation. Once the synchronisation finished, make sure that all components work properly.
Choose a suitable mounting location for the receiver. Commonly, the communication between the
two stations can reach a distance of 100 m in the open field, provided that there are no obstacles
such as buildings, trees, vehicles, high-voltage lines, etc. Radio interference such as from PCs,
radios and television sets can entirely cut off the communication. Take this into consideration when
choosing a mounting location.
3. The Different Functions
Indoor Temperature
1. Touch the indoor temperature section once and press + or – to
switch between the temperature display in °C or °F.
2. Touch the indoor temperature section a second time and press
+ or – to set the high temperature alarm (HI AL), or press
ON/OFF to switch the alarm on or off.
3. Touch the indoor temperature section a third time and press +
or – to set the low temperature alarm (LO AL), or press ON/OFF
to switch the alarm on or off.
4. Touch the indoor temperature section a fourth time to display
the maximum temperature reading. Hold the value pressed to
reset the value.
5. Touch the indoor temperature section a fifth time to display the
minimum temperature reading. Hold the value pressed to reset
the value.
V. 11 – 29/03/2013
WS1080
4 ©Velleman nv