JVC KS-FX711 Service Manual page 11

QQ
3 7 63 1515 0
Removing the head / tape guide
REFERENCE: It is not necessary to remove the slide
chassis assembly.
1. Remove the band attaching the wire to the head.
2. Remove the two screws B, the head and the head
support spring.
3. Remove the pinch arm spring from the tape guide.
4. Remove the tape guide and the pinch spring arm.
CAUTION: When reattaching the pinch arm spring, set
both end of it to the pinch spring arm (
remarked o).
CAUTION: When reattaching the head, set the wires
into the groove of the tape guide (Fig.16).
Removing the flywheel assembly (F) & (R)
TE
L 13942296513
REFERENCE: It is not necessary to remove the slide
chassis assembly.
1. Remove the belt at the bottom.
2. Remove the two polywashers on the upper side.
3. Pull out each flywheel assembly downward.
Flywheel assembly (F)
www
.
Flywheel assembly (R)
http://www.xiaoyu163.com
(See Fig.16 and 17)
(See Fig.18 and 19)
Belt
x ao u163
y
i
Fig.18
http://www.xiaoyu163.com
2 9
8
Slide chassis assembly
Head
Head support spring
Tape guide
o
Pinch spring arm
Q Q
3 6 7 1 3 1 5
Slid chassis assembly
Flywheel assembly (F)
co
.
KS-FX711/KS-FX511
9 4 2 8
B
Head
Tape guide
Fig.16
B
Pinch arm spring
0 5 8 2 9 9 4 2 8
o
Fig.17
Polywasher
Polywasher
m
Flywheel assembly (R)
Fig.19
9 9
9 9
1-11