Table of Contents
Advertisement
ALLON—Turns all PODs on without sequence
ALLOFF – Turns all PODs off without sequence
SEQUP(X) – Sequences up all PODs from 1 to 3, where (X) is the number of
seconds between sequence events (e.g. A 2 second sequence would be SE-
QUP2)
SEQDOWN(X) Sequences down all PODs from 3 to 1, where (X) is the number
of seconds between sequence events (e.g. A 2 second sequence would be
SEQDOWN2)
POD1CURRENT (Reports current draw on Pod 1)
POD2CURRENT (Reports current draw on Pod 2)
POD3CURRENT (Reports current draw on Pod 3)
DHCPON - Enables DHCP on the iP1520
DHCPOFF - Disables the DHCP on the 1520. You will want to disable DHCP
before entering any new network settings via RS232 or the changes will be lost
when connecting the unit to a network.
XXX.XXX.XXX.XXX - Sets the IP address of the unit where 'X'
SETIP
represents your chosen numerals.
SETMASK XXX.XXX.XXX.XXX
- Sets the subnet mask of the unit
where 'X' represents your chosen numerals.
SETGATEIP XXX.XXX.XXX.XXX - Sets the gateway of the unit where
'X' represents your chosen numerals.
SETPDNS - Sets the primary DNS IP address.
SETSDNS - Sets the secondary DNS IP address.
INFO - Shows all current settings
ACTIVATE - Enables the sequence up/down switch on the front of the
iP1520
DECACTIVATE - Disables the sequence up/down switch on the front of
the iP1520
RESTART - Restarts/Reboots the iP1520. Use this command after
making your changes.
WRITING CUSTOM CONTROL INTERFACE
If you wish you design your own driver/interface for the iP1520 this can be done
by incorporating the predefined RS232 protocols as listed in the RS232 Control
.
and Monitoring section of this Manual into your software
Page 13
Advertisement
Table of Contents
