Adjusting The Cutting Height; Adjusting The Handle Height; Operation; Starting The Engine - Toro 20051 Operator's Manual

Adjusting the Cutting Height

If the engine has been running, the muffler will be hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height
as desired. Set all four
wheels to the same
height.

Adjusting the Handle Height

Squeeze the bottom of
the handle halves
together (as shown) and
change the handle holes
in which the pins (A) are
mounted, as follows:
Raise the handle
using hole (B).
Lower the handle
using hole (C).

Operation

Starting the Engine

1. Firmly push in the
primer 3 times with your
thumb, holding the
primer in for a second
before releasing it each
time.
Note: If the air
temperature is below
55 F (13 C), firmly push
the primer in 5 times.
2. Hold the blade
control bar (A) against
the handle.
7
Caution
C
B
A
3. Start the engine using either the ignition key or
the recoil starter.
m-5572
A
4. If the mower does not start in 1 or 2 pulls (or
within 5 seconds using the electric starter), press the
primer button 1 or 2 times and try starting it again.
m-5578
3350-660
2
1-1/4
2-3/8
1-5/8
FRONT
m-5629
m-5614
or
m-5592a
2-3/4
3-1/2
4-1/4
3-1/8
3-7/8
m-5605a
m-5612
m-5606