Sending And Receiving Tables; Files For Programming - Wincor Nixdorf TA59 Product Manual

Sending and Receiving Tables

The tables assigned are stored in a file with default extension .KBT. Such
files can be loaded by the dialogue utility KBUTI.EXE and the tables sent to
the keyboard. They also can be sent directly from such files by the batch
utility SENDKBT.EXE. Accordingly KBUTI.EXE may receive a table from the
TA85P, which then can be viewed or stored in a .KBT file. This, however,
can also be done using RCVKBT.EXE by specifying the file name as a
parameter.
During transmission of tables no keyboard activity is allowed, such as key
presses or key position change otherwise the transmission will be disturbed.

Files for Programming

The files are available on our Internet site www.wincor-nixdorf.com. The
following files is not included in the scope of delivery:
KBUTI.EXE
KBUTIHLP.HLP
SENDKBT.EXE
RCVKBT.EXE
KB2DEF.EXE
KBCHKDEF.EXE
TA59DEF.KBT
README.TXT
TA59xxxx.FRM
Programming the keyboards TA59 is described in detail in the Readme file.
Dialogue utility for programming the keyboard
Help file for the dialogue utility
To send a keyboard table from a file to the keyboard
To receive a keyboard table and save it in a file
To reset a keyboard to the default state
To check for default state (default or programmed)
Default keyboard table for TA59 (!)
Readme file for programming the keyboard
Firmwareupdate-Module (xxxx for release version)
CREATING TABLES WITH KBUTI.EXE
21