Inserting Key Labels - Wincor Nixdorf TA59 Product Manual

INSERTING KEY LABELS

You can change the lettering as follows:
Inserting Key Labels
Below, you will find instructions on how to insert the key labels:
The labels are replaced as follows:
Remove the key cap from the keyboard (see removing the key cap) and
pull the transparent key cap upwards.
The transparent key cover is then released and the label can be removed.
Replace the label and fit the transparent key cover (with the mat and
concave side facing upwards) back into the key cap.
6
Trans pa rent key co ver
with mat and
con ca ve side up
La bel for keys
Key cap
Using a thin object (e.g.
Paper-clip etc.), press upwards
against the plastic cover through
the opening on the underside of
the key. Please refer to the next
chapter for instructions on how to
insert the new label.
Each key should be labelled
individually.
Place the written label on the key
cap.
Insert the transparent key cover
with the mat and concave side
upwards until it clicks into place
in the key cap.