Lenovo ThinkPad T430s User Manual page 139

Table 6. Security menu items (continued)
Menu item Submenu item
Password at restart
Power-On Password
Hard Disk x Password
Fingerprint Predesktop
Authentication
Reader Priority
Security Mode
Password
Authentication
Reset Fingerprint Data
Value Comments
computer goes ahead and loads the operating
system. To prevent unauthorized access, set the
user authentication on the operating system.
• Disabled If you select and enable Password at restart,
a password prompt is displayed when you
• Enabled
restart the computer. If you select Disabled, no
password prompt is displayed; the computer
goes ahead and loads the operating system.
To prevent unauthorized access, set the user
authentication on the operating system.
• Disabled
See "Power-on password" on page 48.
• Enabled
• Disabled
See "Hard disk passwords" on page 48.
• Enabled
Notes:
• Hard Disk 1 means the hard disk drive built
into your computer.
• Hard Disk 2 is displayed on the Password
submenu only if a secondary hard disk drive is
installed in the Serial Ultrabay Slim bay.
• Disabled Enable or disable fingerprint authentication before
the operating system is loaded.
• Enabled
• External ➙ If External ➙ Internal is selected, an external
Internal fingerprint reader is used if attached. Otherwise,
an internal fingerprint reader is used. If Internal
• Internal Only
Only is selected, an internal fingerprint reader is
used.
• Normal If fingerprint authentication fails, you still can start
the computer by entering a password. If you have
• High
selected Normal, enter a power-on password or
a supervisor password; if you have selected High,
enter a supervisor password.
• Disabled
Enable or disable password authentication. If
high security mode is selected, this item appears.
• Enabled
• Enter This option is used to erase all fingerprint data
stored in the fingerprint reader and reset settings
to the factory state (For example, Power-on
security, LEDs, and so on.) As a result, any
power-on security features previously enabled
will not be able to work until they are re-enabled
in the fingerprint software.
.
Chapter 8 Advanced configuration
123