Toro 51544 Operator's Manual page 3

Read operator's
manual
Consult technical
manual for proper
service procedures
Do not open or
remove safety shields
while engine is
running
Wear eye protection
Assembly
Note: Refer to Figures section at the back of the manual.
Note: Always turn off unit and unplug from electrical outlet
before adding or switching attachments.
Blower
1. Slide tube onto blower outlet until tabs on tube snap into latch
(Fig. 2).
Note: Blower tube must be attached to housing when operating in
the blower mode.
Note: Inlet cover must be securely locked into position,
activating interlock switch, before blower will operate. Pointer
on cover will be aligned with pointer on housing when cover is
correctly locked in position (Fig. 3 & 4).
Electrical
shock/electrocution
Disconnect power
Severing of fingers or
hand—impeller blade
Note: Blower is shipped with inlet cover installed.
POTENTIAL HAZARD
• Motor impeller rotates for a few seconds after blower
is turned off.
WHAT CAN HAPPEN
• Rotating impeller can cut or injure fingers.
HOW TO AVOID THE HAZARD
• Never remove inlet cover when motor is operating or
when unit is plugged in.
2