Toro 30440 Operator's Manual page 30

Figure 27
1. Control rod
2. Clevis pin
3. Drive lever
4. Operator Presence Control
lever (OPC)
2. Loosen the nuts holding the swivel connected
to the speed control crank (Figure 28).
Figure 28
1. Speed control rod
2. Swivel
5. Left handle shown
6. Neutral lock
7. Hairpin cotter pin
3. Nut
3. Loosen the upper flange bolts (3/8 x 1-1/4
inches) and flange nut securing handle to rear
frame (Figure 29).
4. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 29).
5. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch)and
flange nuts into mounting holes. Tighten all
flange bolts.
Figure 29
1. Control rod tting
2. Lower mounting holes
3. Rear frame
4. Lower ange bolt (3/8 x 1
inch)
5. Upper ange bolt (3/8 x
1-1/4 inches)
6. High position
6. Adjust the swivel on the speed control rod and
tighten the nuts against the swivel (Figure 28).
7. Adjust the control rod length by rotating the
control rod in the rod fitting (Figure 28).
8. Install hairpin cotter between drive levers and
neutral locks and into clevis pins (Figure 27).
Note: Make sure the clevis pins are inserted
into the neutral locks.
9. Perform the hydraulic linkage adjustments
when the handle height is changed; refer
Hydraulic Linkage Adjustments.
30
7. Lower position
8. Upper mounting hole
9. Handle
10. Flange nut (3/8 inch)
11.