Final Installation Checklist - Samsung DV431AE series User Manual

installing your dryer
4. Review the Exhausting section before installing the exhaust system. Install the ductwork from your dryer
to the exhaust hood. The crimped end of the duct sections must point away from your dryer.
DO NOT use sheet metal screws when assembling ducting. These joints should be taped.
Never use plastic fl exible exhaust material.
Tip for tight installations: install a section of exhaust system to your dryer before putting it in place.
Use duct tape to secure this section to your dryer, but do not cover ventilation slots at the back of the
unit in the dryer cabinet.
5. Review Electrical Requirements section.
BEFORE OPERATING OR TESTING, follow the grounding instructions in the Grounding section.
IMPORTANT – The dryer is produced for a 3-WIRE SYSTEM CONNECTION.
The dryer frame is grounded to the neutral conductor at the terminal block.
Remove the terminal block cover plate.
Insert the power cord through the hole provided in the cabinet near the terminal block.
A strain relief must be used.
Do not loosen the nuts already installed on the terminal block. Be sure they are tight.
Use a 3/8" (1cm) deep well socket.
3-WIRE system connections
A. Center silver-colored terminal block screw
B. strain relief
1. Loosen the terminal block screws.
2. Connect the earth wire(Green/Yellow Striped wire) of the
power cord to the center terminal block screw. Tighten
screw.
3. Connect the neutral wire(Blue wire) of the power cord to
the left terminal block screw. Tighten screw.
4. Connect the live wire(Brown) of the power cord to the
right terminal block screw. Tighten screw.
5. Tighten the strain relief screws
6. Insert the tab of the terminal block cover into the rear
panel slot. Secure the cover with a hold down screw.
C. The power cable H05 VV-F (min.1.9m, min.2.5mm²) must be
of suffi cient length to be connected to the dryer.
6. With a level, check your dryer and make necessary adjustments to the levelling legs.
7. At this time, make sure all exhaust and electrical connections are complete. Connect your dryer to the
power supply, and check operation by using the checklist below.
8. A minimum 30A circuit breaker should be used, and a switch with a minimum contact separation of 3
mm in both poles must be incorporated into the fi xed wiring for dryer disconnection. The dryer should
be positioned so that the disconnection switch is easily accessible to the user.

FINAL INSTALLATION CHECKLIST

Dryer is connected to the power supply and is properly grounded.
Exhaust ductwork is hooked up and joints are taped.
Plastic fl exible duct is NOT used.
Used rigid or stiff -walled fl exible metal vent material.
Dryer is leveled and is sitting fi rmly on the fl oor.
Start your dryer to confi rm that it runs, heats, and shuts off .
English - 16
Neutral
Earth
Live
A
B
C