Cub Cadet GT 2000 Operator's Manual page 20

Cleaning the Engine Intake Screen
The engine intake screen area is located on the lower half of the
dash. It is important to keep this area free of debris. Clean this
area prior to each use. See Fig. 6-4.
Engine Intake Screen
Lubrication
WARNING!
inspecting, always disengage PTO, set parking
brake, stop engine and remove key to prevent
unintended starting.
Front Wheel Axles
Each of the front wheel axles and rims is equipped with a
grease fitting. See Fig. 6-5. Lubricated after every 10 hour of
operation with Cub Cadet 251H EP grease, or an equivalent No. 2
multipurpose lithium grease.
20 s 6 — M
ectiOn aintenance
Figure 6-4
Before lubricating, repairing, or
Grease Fitting
Figure 6-5
& a
djustMents
Steering Housing
The steering housing should be lubricated after every 25 hour of
operation. To access its lube fitting, proceed as follows:
1. Raise the tractor's hood.
2. Locate the grease fitting for the steering housing under the
battery. See Fig 6-6.
Figure 6-6
3. Using a pressure lubricating gun, apply 251H EP grease, or
an equivalent No. 2 multipurpose lithium grease, through
the grease fitting.
4. Close the tractor hood
Steering Shaft
The steering shaft should be lubricated after every 25 hour of
operation. To access its lube fitting, proceed as follows:
1. Working beneath the left side of the tractor frame, locate the
lube fitting near the rear of the steering housing. See Fig 6-7.
Figure 6-7
Grease Fitting
Grease Fitting