Path Settings - Pyle PIPCAM5 User Manual

When motion detection triggered, there will be beep sound during the alarm, you can control this sound here.
Enable it, there will be sound once alarmed.
Cancel it, there will be no sound once alarmed.
Record on Alarm
If you want the camera do recording for every alarm, choose Record on Alarm to enable it.
If you do not want the camera do recording once alarm triggered, cancel it here
Once alarm occurred, there will be some representation:
1. The corresponding status light turns Red and keeps blinking.
Figure 10.7
2. If you set Sound on Alarm, plug an earphone or a speaker to the computer you use, you can hear the beep
sound when alarmed. (Figure10.6)
3. If you set Record on Alarm, the camera will record automatically for approx one minute. You can find the
record file in the folder which you set. (Figure 10.9)
4. If you set Send Mail on Alarm, you will receive email alarm alert once motion triggered. (Figure 10.0)
5. You can also set Scheduler to enable the camera sends emails during a special time range you want.
(Figure 10.5)
6. If you set Upload Image on Alarm, it will upload images to the FTP Server you set already once alarmed.
(Figure 10.4)
NOTE: Each alarm only last for approx one minute, all these above functions for motion detection triggered
only.
REC Automatically and Save to PC
When you enable motion detect and open the camera monitoring page on the PC. If there is an alarm
triggered, REC will start automatically for several seconds and save to the PC.
New Feature: Start the motion detection compensation and Alarm notification by Http.

3.22 Path Settings

Figure 10.8
Here you can set record path and alarm record path for the camera
More Security ,More Convenience
Figure 10.6
- 45
-
.
.