Cub Cadet HB425 Operator's Manual

Removing Unit From Carton Assemble The Unit
1 1 2
Remove all contents from Insert blower tube into
the carton. blower outlet and turn
clockwise until it locks into
place.
Assemble The Unit Starting The Unit
10 X
5
6
Place unit on a level surface. Press primer bulb 10 times,
Fill fuel tank.
or until fuel is visible
Starting The Unit
1 9 10
DO NOT squeeze throttle Pull rope 5 times.
control.
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING THE UNIT.
NEED HELP?
769-05663 P00
HB425
4-Cycle Suitcase Blower
Operator's Manual
3
Insert nozzle onto blower
tube and turn clockwise until
it lock into place.
Primer
Bulb
7
Move choke lever to
Position 1.
5 X
11
Move choke lever to
Position 2 .
Call 1-877-282-8684 in U.S. or 1–800–668–1238 in Canada
No Tools Required!
4
Place the unit on a level
surface, remove the oil plug
from the crankcase, and pour
the entire bottle of oil into the
fill hole.
8
Crouch in starting position.
3-5 X
12 13
Pull rope 3-5 times to start Continue to squeeze
engine. Squeeze throttle throttle. Move choke lever
control and allow unit to to Position 3.
warm up for 60 seconds.
On/ Off Switch
Blower Outlet
Blower Tube
Oil Plug
Nozzle
DIDN'T START?
Repeat these instructions.
IF engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to operator's
manual for additional starting and
troubleshooting information
14
Continue to squeeze
throttle. Warm unit for an
additional 30 seconds to
complete warm-up. Unit
may be used during this
time.
Throttle Control
Primer Bulb
Starter Rope
7/10