MerCruiser Vazer 100 Owner's Manual page 97

Front trim cylinder anodes
Rear trim cylinder anodes
Gearcase anodic plate
Bearing carrier anode
Gimbal housing anode
Anode kit (if equipped)
In addition to the corrosion protection devices, take the following steps to inhibit corrosion.
1. Paint the power package. See Painting Your Power Package.
2. Annually spray the power package components on the inside of the boat with Corrosion
Guard to protect the finish from dulling and corrosion. You may also spray external
power package components.
3. Keep all lubrication points, especially the steering system, shift and throttle linkages,
well lubricated.
4. Flush the cooling system periodically, preferably after each use. See Flushing Your
Power Package.
90-899883275 MARCH 2008
Description
Mounted on the front on each of the trim
cylinders.
Mounted on the rear on each of the trim
cylinders.
Mounted on the underside of the lower
gearcase.
Located in front of the propeller, between
the front side of the propeller and the gear
housing.
Mounted on the bottom of the gimbal
housing.
Mounted to the boat transom on opposite
MerCathode Kit sides of the sterndrive. The MerCathode
(if equipped) controller is mounted on the engine or on
the inside of the boat transom.
Mounted to the boat transom.
Location
Section 5 - Maintenance
Figure
26226
26227
26225
26228
26224
26234
26300
Page 89