Kenmore 635.83131 Owner's Manual page 5

The Electronic Filter is designed so that it can be cleaned
using Zap-It! or common household detergents. Use dish
washing detergent and hot water, make a good soaking
solution. Completely immerse the Electronic Filter and soak
for 20 to 30 minutes. After the Electronic Filter has soaked
sufficiently, it should be gently agitated in the water until
clean. If the Electronic Filter is extremely dirty, spray it with
Zap-It, a cleaning solution made specifically for this air
cleaner. (You can also use a common household cleaner.)
Let the filter soak for five minutes then proceed with the
washing instructions.
Thoroughly rinse both sides of the Electronic Filter. If a
sprayer is available, spray with water. Check to make sure
each layer of the Electronic Filter is clean. Shake as much
water out of the Electronic Filter as possible. Wipe along
the ionizing wires carefully with a cotton swab and alcohol.
After reinstalling the Electronic Filter, operate the unit in the
Dry position for one hour to ensure that it is thoroughly dry.
Failure to do so can cause permanent damage to
Electronic Filter.
Washing Tips:
When handling the Electronic Filter, be careful not to
damage wires or metal plates since this could cause
excessive snapping.
After the first cleaning, the metal surface of the Electronic
Filter may not be as shiny as before. This is normal and
does not reduce effectiveness.
Cleaning the Negative lon Generator Needle
The Negative Jon Generator needle should be cleaned
about once every two months. Make sure the air cleaner is
turned off and unplugged from the outlet for 5 minutes
before cleaning the needle.
To clean the needle, simply wipe it with a cotton swab
dipped in alcohol. Then use a dry cotton swab to make
sure the needle is dry.
NEGATIVE
ION GENERATOR
The Pre-Filter
The Pre-Filter is located in the front of the Electronic Filter.
To clean it, slide it out and rinse thoroughly with clean
warm water. Set it aside to dry.
The Charcoal Filter
Although the Charcoal Filter is an optional replacement
filter, we recommend its use for the operation of your air
cleaner to help maintain efficiency.
During normal use, lint and dirt may build up on the Char-
coal Filter and can be removed with a vacuum cleaner
using a brush attachment.
The effectiveness of this Charcoal Filter will gradually
diminish over time. If your unit is used continuously, it
should be replaced every three months. Replacement
filters are available at Sears retail stores.
Reinstalling the Electronic Filter
First, slide the Pre-Filter into the slots in the front of the
Electronic Filter and slide the Charcoal Filter into the slots
provided in the back. Using the handles, align the
Electronic Filter with the ribs on the inside cabinet wall.
Gently slide the Electronic Filter into place.
Note: The label on top of the Electronic Filter will help you
replace the Pre-Filter and Charcoal Filter into the Electronic
Filter.