Microplex LOGIJET T4 Operator's Manual page 5

_______________________________________________________________________________________________
Chapter
7.23. Contrast (Density) Setting
7.24. Image Shifting to the X-Direction
7.25. Image Shifting to the Y-Direction
7.26. Selecting the Light Sensor Type
7.27. Automatic Sync Sensor Adjust
7.27.1. Overview
7.27.2. Example
7.28. Manual Sync Sensor Adjust
7.28.1. Overview: Level and Current Adjusting
7.28.2. Description of Level and Current Adjusting
7.28.3. Example
7.29. Peripheral Device Activation (Tear Off Edge, Cutter)
7.30. Selecting the Tear Off Mode (Option: Cutting Mode)
7.31. Selecting the Print Mode
7.32. Adjusting the Tear Off Position (Option: Cutting Position)
7.33. Configuration of Network Parameters (IP Address, e.g.)
8. Using the RFID Functions
8.1. Integrated RF Write/Read module
8.1.1. CE - Conformity
8.2. RFID Panel Functions
8.2.1. Selecting the RFID Mode
8.2.2. Selecting the Communication Protocol
8.2.3. Adjusting the Transponder Position (Tag Position)
8.2.4. Adjusting the Number of RFID Access (Timeout)
8.2.5. Adjusting the Transmission Speed (Bit Rate)
8.2.6. Reading the Label Identification Number automatically
8.3. Data Interface Status Out
8.4. IDOL Commands for RFID
8.4.1. Overview Function Group RFID
8.4.2. Reading the Label ID Number (Prior to the Print Process)
8.4.3. Writing Data into a Data Block of the RFID Label
8.4.4. Generating a Page ID Number, Receiving the RFID data after Printing
8.5. Syntax of RFID Data (Status Messages)
8.6. RFID Errors
_______________________________________________________________________________________________
MICROPLEX Operator's Manual LOGIJET T4 /T6 /RFID
Contents 5
Page
85
86
88
90
91
91
92
93
94
95
96
98
100
102
105
106
109
109
109
111
111
112
113
119
120
121
122
123
123
126
127
128
130
132
Edition 1.3