Table of Contents
Advertisement
STOPPING THE TRACTOR
•
Fully depress the brake pedal to bring the
tractor to a complete stop. Push downward on
the parking brake lever and release the pedal
to engage the parking brake. See Figure 16.
•
Depress the rear of the PTO switch to
disengage the PTO.
•
Place the throttle control lever in the "SLOW"
position and allow the engine to idle for about
one minute.
•
Turn the ignition switch to "OFF'" and remove
the key from the switch before dismounting.
•
Depress the button in the center of the seat belt
buckle to release the seat belt.
USING THE FORWARD AND REVERSE PEDALS
The hydrostatic transmission provides constantly
variable ground speeds within the speed rating of
each (HI/LO) transmission range. The tractor speed
is controlled by the forward and reverse pedals on
the front of the right running board.
The forward and reverse pedals are self neutraliz-
ing. The transmission and pedals return to neutral
when the pedals are released and the tractor will
slow to a stop. NOTE: Use the brake pedal to stop
the tractor.
•
To move forward, slowly depress the forward
control pedal (See Figure 16) until the desired
speed is achieved. The speed of the tractor is
directly related to the distance the pedal is
depressed.
PARKING
BRAKE
LEVER
Figure 16
•
To move in reverse, check that the area behind
is clear then slowly depress the reverse control
pedal. See Figure 16.
BRAKE
PEDAL
Depress
Depress
to go in
to go
Reverse
Forward
IMPORTANT: Do not use the forward or reverse con-
trol pedals to change the direction of travel when the
tractor is in motion. The abrupt direction change may
unseat the operator and will cause premature wear in
the transmission. Allow the tractor to stop before
changing directions.
USING THE HI/LO RANGE SHIFT LEVER
WARNING:
stopped before engaging or disengag-
ing the transmission Hi/Lo range shift
lever. Shifting while the tractor is in
motion will cause damage to the
transmission.
WARNING: Always maintain a tractor
speed that allows for complete control
and stability of the machine. Be aware
of dangerous areas or conditions.
Referring to Figure 17, pull the lever to the right
side of the slot to clear the shift gate, then shift the
lever as follows :
HI range — Shift the lever fully forward in slot.
Forward speed 0 to 8.0 mph.
Reverse speed 0 to 4.0 mph.
Hi range is normally used for transport and can be
used with some tractor attachments
LOW range — Shift the lever fully rearward in slot.
Forward speed 0 to 4.0 mph.
Reverse speed 0 to 2.0 mph.
Low range is recommended for use with most PTO
driven tractor attachments. Low range must be
used when climbing or descending slopes.
NEUTRAL — Shift the lever to the center of slot.
Disengages the transmission drive.
Use ONLY for towing or moving the tractor when
not under power.
PTO REVERSE
OVERRIDE
SWITCH
18
The
tractor
must
LOW
N
HI
HI/LO RANGE
SHIFT GATE
SHIFT LEVER
Figure 17
be
Hide quick links:
Advertisement
Table of Contents
