Cub Cadet 5252 Operator's Manual page 32

HEAD LIGHT BULB REPLACEMENT
The tractor is equipped with headlights. If one of the
bulbs should burn out, replace the bulb as follows:
• Fully raise the hood.
• Pull the wire harness plug from the bulb/socket
assembly to unplug the wire harness. See
Figure 33.
WIRE
HARNESS
PLUG
Figure 33
• Turn the bulb/socket assembly approximately a
quarter turn counterclockwise to align its tabs
with the notches of the reflector, then remove
from the reflector.
• Replace with a new bulb/socket assembly (Cub
Cadet No. 725-04084).
• Align the tabs of the new bulb/socket assembly
with the notches of the reflector and insert the
bulb.
• Turn the bulb/socket assembly clockwise to
lock in place. Push the wire harness plug fully
into the bulb socket.
SERVICING ELECTRICAL SYSTEM
Fuses are installed to protect the tractor's electrical
system from damage caused by excessive amper-
age. Always use the same capacity fuse for
replacement. If the electrical system does not func-
tion, check for blown fuses. See Figure 34
If you have a recurring problem with blown fuses,
have the tractor's electrical system checked by your
Cub Cadet dealer.
GOOD
Figure 34
REFLECTOR
BULB/SOCKET
ASSEMBLY
BAD
Accessing the Fuse Center
The fuse center is located on the inside right of the
dash panel. To access the fuse center, remove the
dash panel insert by removing the two screws. See
Figure 35.
To cover the fuse center, reposition the dash panel
insert in the dash and secure with the two screws.
Instrument Panel Fuses
The instrument panel's circuitry is protected by the
two fuses in the fuse center. If the instrument panel
does not function properly, check the fuses.
• Pull the two fuses from the fuse center and
check their condition. Replace a blown fuse
with the same capacity fuse (3 Amp). Refer to
Figure 36.
Relays
The PTO relay and starter relay, located in the fuse
center, maintain power to each of those circuits. If
one of the circuits is not functioning properly, have
your dealer electrically check the relay. See Figure
36.
32
SCREWS
DASH
PANEL
INSERT
Figure 35
INSTRUMENT
PANEL FUSES
(3 AMP)
STARTER
RELAY
PTO RELAY
FUSE
CENTER
Figure 36