Table of Contents
Advertisement
NOTE: To exit from any point during SETUP procedure or to save the newly made changes, simply press and hold the
RESET key until the display shows 'SAVING'. When the display shows 'SAVING', it is indicating that the unchanged and
the newly made changes are being saved in the EEPROM for permanent storage. It is important that the above step be
performed any time changes are made to the configuration of the unit and before power is removed. If not done so,
all the new changes will be lost. The unit will, however, maintain the old settings.
CHANNEL CONFIGURATION
After entering correct pass-code and selecting the blinking 'CH' (ref. SETUP section), the display shows 'SLCt CH' (for
"Select Channel"). Use
'CHANEL x' (where x=channel#). Once the desired channel # is displayed, push SETUP key to go on to setup
parameters for the displayed channel #.
Setup For Input Type
The display will briefly show 'IP TYPE' (for "Input type") after which the
present input type for the selected channel will be displayed. Various inputs
available are: J T/C, CR.AL T/C (Chromel Alumel, type K T/C), T T/C, E
T/C, CURRENT, or VOLTAGE. If the unit has a noble metal thermocouple
option, then only one T/C can be selected i.e. B T/C, R T/C, or S T/C. Use the
DIG
key to display the desired input type. Once the desired input type is
displayed, push the SETUP key to enter that input type and go to Setup For
Channel ON/OFF.
NOTE : If you have a millivolt input unit (instead of thermocouple), the various
types of inputs selectable are CURRENT, HI VOLT and LO VOLT (for millivolt input).
Setup for Voltage or Current Input:
Setup For Channel ON/OFF
After selecting input type, the next parameter for configuration is Channel
ON/OFF, which determines whether a channel is scanned or not. If for any reason
a channel is not being used, it must be turned OFF. In this way the unit will not
spend any time scanning it. This will also prevent the unit from displaying a
'HELP' message on a channel that has nothing hooked up to it. Use
to select the desired setting. If a channel is OFF, the display will show 'CHx
OFF' , and if the channel is ON the display will show 'CHx ON' (x=channel #).
Use
DIG
key to display the desired ON/OFF setting, and then push SETUP
key to enter that setting and go on to setup Decimal Point Position.
Setup For Decimal Point Position
After turning a channel ON or OFF, the next parameter for configuration is setting
the decimal point position. This is indicated by the display showing ' 9999' .
DIG
key moves the decimal point through all the possible positions. After
'9.999', the display goes to '9999' which indicates a display with no decimal point.
Use
DIG
key to move the decimal point to the desired position, and then push
SETUP key to enter that setting and go to setup High Scale.
DIG
key to display the desired channel. Selected channel will be displayed in the format
DIG
key
Page 11
Advertisement
Table of Contents
