Replacing The Light Bulb - Twin-Star International DFS-550-0 Homeowners Operating Manual

CARE AND MAINTENANCE
CLEARANCE TO COMBUSTIBLES
Keep electrical cords, drapery, furniture and other combustibles at least 3 ft (0.9 m) from the front of the
heater and away from the sides.
CLEANING TRIM
Clean the metal trim using a soft cloth, slightly dampened with a citrus oil-based product and buff with
a soft, clean cloth. DO NOT use brass polish or household cleaners as these products will damage the
metal trim. Purchase citrus oil-based products at a hardware store.

REPLACING THE LIGHT BULB

This electric stove uses one clear 120-V, 40-watt, E12 socket base light bulb (candelabra base, B bulb).
Access the 40-watt bulb through the rear access panel (see illustration below).
1. Turn the main power switch off, and then unplug the power cord from the wall outlet.
2. If the stove has been operating, let the unit cool at least 2 hours.
3. Loosen the screws holding the stove back panel to the main body of stove (see Fig 4).
4. Pinch the spring clip to loosen the spindle, and gently turn and pull the rubber gromet out of the
spinner motor shaft. (see Fig.5).
5. Pull the spinner out of the bracket.(see Fig 5).
6. Remove light bulb and replace with one clear 120-V, 40 Watt E12 Socket base light bulb (Fig.6).
7. Place rear access panel back into position and tighten screws (do not over-tighten).
1. Loosen Phillips
head screws
2. Remove back
panel to access
light bulb
3. Replace the
light bulb
Fig. 4
WARNING:Do not exceed 40 watts per bulb. Use of higher rated bulb may result
in a fire, causing property damage or personal injury.
Ember bed
light bulb
Spinner
E-5
Pinch this spring clip to
loosen. Gently turn and
pull the rubber grommet
from out of the motor
shaft.
Fig. 5
Light bulb holding spring
Pull
Pull
Fig. 6