Operating The Controller; Setpoint Value - Omega Engineering PHCN-410 Operator's Manual

keypod to store this value into mem
3-2
value.
When the desired value is showing in the display, p
CAL/ENTER
desired
displaye A keys to change the 4 ond the
panel.
Use
front
keypod, until the Lo onnu SET/TEMP
Setpoint Value:
Press the
v&e into me
To Enter the lo
k store this keypod
dis
CAL/ENTER
desired value.
When the desired value is showing in the
display change the A keys to 4 and
ann
front ponel.
3.
4.1. 2
1.
2.
3.
Use the
Setpoint Value:
Press the SET/TEMP keypad, until the Hi
pH buffer 4.01 or 10.01. Press the CAL Key.
4.1. 1
At this time the "CAL" annunciator light will appear. When the
light goes off, the slope is calibrated.
1.
2.
To
Enter the Hi
Setpoints Hi/Lo 4.1 Entering PHCN-410 stondord
place the electrode
in
water ond
electrode with distilled
pH buffer 7.00. Rinse
the
pH electrode from the
4.
Remove the
pH Electrode
Operating the Controller
Calibrating the