Summary of Contents for Omega Engineering PHCN-410
Page 1
OMEGA... Your Source Process Measurement and TEMPERATURE Thermocouple, RTD & Thermistor Probes, Connectors, Panels 81 Assemblies B Wire: Thermocouple, RTD &Thermistor m Calibrators & Ice Point References B Recorders, Controllers & Process Monitors B Infrared Pyrometers PRESSURE/STRAIN FORCE @’ Transducers &...
Controller Operator ’ s Manual Operating the Controller Section 4 Entering PHCN-410 Hi/Lo Setpoints 4.1.1 To Enter the Hi Setpoint Value 4.1.2 To Enter the Setpoint Value..Error Messages Section 5 Specifications Section 5.1 Specifications .4-l 5 -l .l Unpacking the Controller...
LED display, two SPDT mechanical relays, and a fixed 4-20 output. Figure Front Panel Display l-l. Keypad Description The PHCN-410 features four keys for entering all set-up parameters and performing calibration. (Refer to Figure l-l SElITEMP CAl/ENIER Select setpoint reby modes...
1.4 Front Panel Displays Controller in P” pH calibration and 10.01; CAL annunciator off when calibration complete High alarm relay activated 1.5 General Information We recommend that you bench-test all equipment prior to installation. This requires wiring the equipment and checking relay and output functions as well as also a good time to initially calibrate the (see section 3).
Page 7
When the load is connected to the NO and COM, the re open until the setpoint is reached. When the load to the NC and COM, the relay is closed until the reached. The wiring configuration is application depend The PHCN-410 has a fixed 4-20 mA output.
Page 8
Installing the Controller Notes Calibrating the pH Electro 3.1 Calibrating the pH Electrode Calibration of the electrode to the pH measurement. It is also necessary to recalibrate the periodically. The frequency of recalibration is system dep pH calibration procedure is as follows: Connect the combinotion pH electrode ond compensation probe (if using ATC) to the m...
At this time the “CAL” annunciator light will appear. When the light goes off, the slope is calibrated. pH buffer 7.00. Rinse stondord place the electrode Operating the Controller 4.1 Entering PHCN-410 Hi/Lo Enter the Hi Setpoint Value: 4.1. 1 Press the SET/TEMP keypad, until the front ponel.