Manual Calibration Instructions
For Models: Omega | Quantum | Paragon | Omega II | Quantum II | Paragon II | Alpine | Advance 200 |
Advance 300 | Advance 400 | Advance 500 | TSC2 | TSC3 | TSC4 | TSC5
If the unit has a "Select" button and not the "Enter" button use the select to
IMPORTANT
select the engineering mode on the screen.
F1
Entering Diagnostics Mode
1
Turn the treadmill power to ON.
2
Place the safety key in position on the console.
3
Simultaneously press and hold the incline "+" (s) and speed "-" (t) buttons for about five seconds. (F1 & F2)
4
The console will beep and display the software version in the one of the two following windows;
For Models Omega II | Advance 200: in the Time window.
All other Models: in the Calories/Elevation window.
Do NOT stand on the running belt when calibrating. Use the guide rails instead.
WARNING
5
Press Start. The running belt should begin moving.
6
The Speed or Speed Pulse window will display the actual speed of the running belt. This should be
0.5mph.
7
This should be 0.5mph (+ or - .05). If the speed is not within the proper start range, adjust the speed cube located on
the lower control board. (F3)
Note: When adjusting the speed cube, turn the screw right to increase the speed and left to decrease the speed. Use small
increments as the speed cube is sensitive and will respond to each change.
DO NOT PUSH DOWN HARD ON THE SCREW.
Tip: Another way to verify the speed is set correctly: Count the running belt revolutions per minute. At 0.5mph the running
belt should make 4 revolutions per minute for the Alpine and Advance 500 and 4.5 revolutions per minute for all other units.
IMPORTANT
To exit the Engineering menu, press and hold "Stop" for three seconds.
Manual Calibration | Pre Auto Cal _rev1.5 | 08/17/07
Calories / Elevation
Speed / Pulse
INCLINE
Distance / Laps
Time
UP
DOWN
SELECT
STOP
START
FAST
UP
ELEVATION
TRANSFORMER
F3
10.46
SPEED
INCLINE
DOWN
UP
INCLINE
START
SLOW
SELECT
SPEED
SPEED CUBE
F2
0.87
Time
Distance
Speed
Pulse/Laps
Elevation
Calories
SPEED
DOWN
SPEED
STOP
HOLD TO PAUSE