Advertisement
Auto Calibration Instructions
For Models: RT1 | T51 | T52 | T53 | T54 | T605 | T805 | CST3 | CST4 | CST5 | T25 | T35 | 1.2T | 2.2T | 3.2T | 4.2T | 5.2T | 30516 | T61 | T62 | T63 |
T64 | T50 | T70 | CST3.5 | CST4.5 | PST6 | PST8 | T650 | T805 | 30517 | T10K | 30518 | T95 | CST3.5x | CST3.6 | CST4.6 | PST Pro | PST6 | PST8 |
T71 | T72 | T73 | T74 | 1.3T | 2.3T | 5.3T | T4 | T6 | DT680 | LS925T | RST5.6 | RCT7.6 | 30519 | 30516 | 30517 | WT751 | WT951 | 610T | 620T | 700T |
720T | 730T | 820T | 830T | 930T
F1
Distance / Laps
%
Manual
Intervals
Rolling
%
Hill Climb
Race
THR Zone
3
%
2
%
1
START
%
SELECT
SELECT
INCLINE
Entering the Engineering Mode
1
Turn the treadmill power to ON.
2
Place the safety key in position on the console.
3
Simultaneously press and hold (for about five seconds) the incline "+" (s) and speed "-" (t) buttons.(F1 & F2)
For Model RT1: Simultaneously press and hold the 1 and 10 quick speed buttons for about three seconds. (F3)
4
The console should beep three times and ENG0 (EN90) should be displayed.
This indicates you are in the engineering menu.
Note: if ENG0 (EN90) is not displayed, but ENG (EN9) is displayed with another number at the end, you are still in the
engineering menu. Use the "+" (s) or "-" (t) buttons to navigate to the correct menu. See following instructions.
Auto Calibration
Do NOT stand on the running belt when calibrating. Use the guide rails instead.
WARNING
After following the steps above you will have three steps left to complete the calibration process.
1
Press the speed "+" (s) or "-" (t) buttons until ENG2 (EN92) is displayed.
For Model RT1: Press the "Enter" button untill the display reads "Auto Set".
2
Press and hold the "Enter" button for about three seconds to select.
For Models 1.2T | 2.2T | 3.2T: Press and hold the "Select" button for about three seconds to select.
For Models T25 | T35: Press and hold the "Start" button for about three seconds to select.
For Model RT1: Press the "Start" button to select Auto Set mode. (F3)
3
Press the "Start" button to begin.
For Models 1.2T | 2.2T | 3.2T: Press the "Select" button to begin.
The running belt will begin moving and will automatically begin the auto-calibration sequence to properly set and store the
speed values. Upon successful calibration there will be four beeps and it will automatically exit the Engineering Mode and will
return to the original screen. The whole process will typically take about two minutes.
Auto Cal _rev1.5 | 08/17/07 JHP
10
mph
9
mph
8
mph
7
mph
Time
6
mph
5
mph
Weight Loss
Hill Run
4
mph
Custom 1
Custom 2
3
mph
2
mph
1
STOP
mph
SPEED
F2
F3
Advertisement
