Advertisement
Advertisement
Table of Contents
Related Manuals for Omega Engineering Handyport Wireless Adaptor OM-SQ-RF-ADAP
Summary of Contents for Omega Engineering Handyport Wireless Adaptor OM-SQ-RF-ADAP
- Page 3 Setting up the HandyPort The OM-SQ-RF-ADAP Handyport Wireless adaptor provides wireless communications via the data logger’s serial port. The OM-SQ-RF-ADAP HandyPort has a factory default of 9600 Baud. ® To use from the box you will need to change the OMEGALOG serial baud rate to 9600 (the OM- SQ2010/SQ2020/SQ2040 series data loggers normally communicates at 115k baud).
- Page 4 Push the RST button of the Handyport if it is communicating correctly the link LED (on the Handy- port) will start to flash every second press the Enter Key after 5 seconds. Type ‘B’ and press the Enter Key. Type ‘7’ (for the baud rate 115200) and press the Enter Key. Page 4...
- Page 5 Type ‘X’ (to save the setup) the press the Enter Key. Repeat the procedure with the second Handyport. Exit the Hyper Terminal program. Page 5...
- Page 6 Using the Handyport Connect the Handyport to the RS232 Serial Com port of the PC with a 9-pin standard serial cable and connect the power supply (USB lead or separate power pack). Connect the second Handyport to the data logger with a null modem serial cable LC75 then connect the power supply (this could be from the same power pack as used with the data logger or a sepa- rate power pack).
Need help?
Do you have a question about the Handyport Wireless Adaptor OM-SQ-RF-ADAP and is the answer not in the manual?
Questions and answers