Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Omega Engineering RS232
Summary of Contents for Omega Engineering RS232
-
Page 3: Table Of Contents
Configuring the NetPort Ethernet to RS232 Adaptor Contents References……………………………………………….4 Overview………………………………………………...4 Prerequisites……………………………………………..4 Installing the ‘Installer’ Application…………………….5 Configuring the Device………………………………….6 Connecting the NetPort Device…………………….….6 Running the Installer Application………………...…….6 Configuring the NetPort Serial port……………..……..9 Page 3... -
Page 4: References
*NOTE* In case of any problems connecting to a Logger through a network, please seek assistance from your IT administrator before contacting OMEGA Engineering. For more detailed information relating to the NetPort device the reader should refer to the Lantronix Device Installer User Guide document [1]. -
Page 5: Installing The 'Installer' Application
Installing the ‘Installer’ Application The Lantronix Installer program referred to in the remainder of this document must be installed; this application will allow you to configure the device. The installation program can be found in the ‘\Tools\NetPort’ folder in your OMEGALOG directory (also on the OMEGALOG To install: 1. -
Page 6: Configuring The Device
Configuring the Device Connecting the NetPort Device Connect the device between your data logger and Network as follows:- 1. Connect an Ethernet cable to the NetPort port labelled ‘10/100Mbit/s Ethernet’ 2. Connect the NetPort 9-pin D-Type serial connector to the logger’s serial port. 3. - Page 7 Press the button. This will search your local network for any XPort devices. When found the devices will be listed in the left hand window. Select the device you wish to configure from the list. Page 7...
- Page 8 In the right hand window move the slider down and until you see the ‘Network’ settings Before proceeding you must speak to your network administrator to get the following information regarding the network you will be connecting the XPort device to: •...
-
Page 9: Configuring The Netport Serial Port
Configuring the NetPort serial port. In the right hand window move the slider down and click the mouse pointer in the ‘Ports’ field. Click on the button circled below. Page 9... - Page 10 The ‘Port Collection Editor’ window will be displayed. Page 10...
- Page 11 In the Port Collection Editor window set only the following parameters by clicking on the field and typing in the values or selecting them from the pull down list if present. Under ‘UDP Datagram Mode’ Datagram Mode’ ‘Datagram Type’ Under ‘Active Connection’ ‘Remote Host’...
- Page 12 Page 12...
- Page 13 Page 13...
- Page 14 Page 14...
Need help?
Do you have a question about the RS232 and is the answer not in the manual?
Questions and answers